![]() If you need to setup call routing over different GSM outgoing groups, please look at following FAQ that will explain what you need to configure:Ĭall routing - SIM selection based on called numberįor incoming calls you can define 2 groups with the different behaviour and assign them to the GSM modules. If you are using only outgoing GSM group 1, you don't have to change anything. In default LCR table is already configured to send calls from VoIP to GSM over the GSM outgoing group 1. In firmware 1.20 the LCR process has been changed, you can find more information about the change here:Ĭall routing - Changes in call routing in firmware 1.20+ compared to earlier versions on 2N® VoiceBlue Next You need to create LCR rule for defined prefixes. in our country prefix 6 and 7 with a nine digits in the number. Configuration of the LCR (Least Cost Routing)The GSM operator has e.g.Ring tone to VoIP: Select From GSM from the drop box. ![]() SIP proxy (GSM->IP): Enter the IP address of the Session Manager and Port number.SIP proxy (IP->GSM): Enter the IP address of the Session Manager and Port number.In the IP addresses section, enter the following:.In case you leave there 0.0.0.0 it will be open for all traffic. You can specify the IP address and port from which SIP packets will be accepted. SIP proxy (IP→GSM) is designed for secure communication with traffic from your Avaya Aura Communication Manager only. The configuration would be as shown in the figure below.įor the setting of the trunk between the 2N® VoiceBlue Next and Avaya Aura Communication Manager you need to configure SIP proxy (GSM→IP) for GSM incoming calls.The Communication Manager is configured to communicate to the 2N VoiceBlue via a SIP Trunk configured on the Session Manager.We have an IP network in which an Avaya solution (that consists of Communication Manager, System Manager, Session Manager and an Avaya G430 Gateway), several SIP phones and 2N® VoiceBlue Next are connected.2N® BlueTower (2 to 8 channels), 2N® StarGate (2 to 32 channels).2N® BRI Lite, 2N® BRI Enterprise (2 channels).If you are currently using firmware that is older than version 1.20 (1.19 and lower) please upgrade your firmware version or go here: old routing, where you will find FAQ on how to set this function in older FW version.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |